Quick Start Guides
Active Marker Tracking
Prepare Setup Area
Camera Mount Structures
Cabling and Wiring
Aiming and Focusing
Rigid Body Tracking
Camera Video Types
Reconstruction and 2D Mode
Motive Batch Processor
Motive UI Pages
Data Management pane
Data Streaming pane
Edit Tools pane
Graph View pane
External Device Setup
AMTI Force Plate
Bertec Force Plate
Baseline Lower Body (20)
Back to the Baseline Markerset page
Front view of the Baseline Lower Body (20) markerset.
Back view of the Baseline Lower Body (20) markerset.
Baseline Lower Body (20) Placements
Note that the waist markers are the key markers in modeling the pelvis bone, which is the major segment governing the other subsequent skeleton segments. For best results, avoid placing the waist markers in a rectangle shape. When tracking multiple actors with similar proportions, introduce an offset to one of the WaistBack marker, or the WaistCMarker (included only with the 13 additional markerset), to create an asymmetrical arrangements.
Placed the marker on the protruding bone located on the front of the pelvis (left/right anterior iliac spine bone). The prominence can be palpated from left and right side of the waist.
Place the WaistLBack and WaistRBack markers above left/right hip; about 10 cm above the hip joint.
Place the marker on the front side of the thigh, along the midline. For best results, slightly offset the height of the left and right markers to introduce the asymmetry.
Place the marker on the outter prominence of the knee joint; on the lateral epicondyle of the femur. Palpate the knee for the protruding bone from the upper leg, and place it right on the axis. Ask the actor to flex and extend the knee few times to confirm that the markers are placed along the axis and maintain stationary throughout the range of motion cycles.
Place the marker on the shin bone; on the midline of the lower leg. For best results, slightly offset the height of the left and right markers to introduce the asymmetry.
Place the marker on the protruding bone outside of the ankle joint; on the lateral end of the malleolus bone.
Place the marker just before the little toe joint; on the distal end of the fifth metatarsal bone.
Place the marker just before the big toe joint; on the distal end of the first metatarsal bone.
Hinged Toe Markers
Hinged toe markersets create toe segments in the skeleton. Two additional markers are added to each foot, one on the toe-tip and another on the heel. The hinged toe markers are included in all baseline markersets except for Baseline (37) and Upper Body markersets.
Place at the center of the heel.
Place the marker on the tip of the second toe; next to the big toe.
Retrieved from "
This page was last modified on 29 March 2016, at 16:52.
All data and information contained in or disclosed by this wiki is proprietary information of NaturalPoint Corporation and all rights therein are expressly reserved. By accepting this material the recipient agrees that this material and the information contained therein is held in confidence and in trust and will not be used, copied, reproduced in whole or in part, nor its contents revealed in any manner to others without the express written permission of NaturalPoint Corporation. Information in this document is preliminary and subject to change and does not represent a commitment on the part of NaturalPoint Corporation.
2019 NaturalPoint, Inc. DBA OptiTrack