Version:
Motive 2.2
Motive 2.1
Motive 2.0
Motive 1.10
Navigation
Main page
Tutorial Videos
Page References
Quick Start Guides
Getting Started
Precision Capture
Active Marker Tracking
Hardware Setup
Overview
Prepare Setup Area
Camera Placement
Camera Mount Structures
Cabling and Wiring
Aiming and Focusing
Motive Documentation
What's New
Overview
Installation
Motive Basics
Calibration
Markers
Assets
Rigid Body Tracking
Skeleton Tracking
Camera Video Types
Data Recording
Data Types
Reconstruction and 2D Mode
Labeling
Data Editing
Data Export
Data Streaming
Motive Hotkeys
Motive Batch Processor
Motive UI Pages
Application Settings
Builder pane
Calibration pane
Control Deck
Data Management pane
Data Streaming pane
Devices pane
Edit Tools pane
Graph View pane
Info pane
Labeling pane
Markerset pane
Properties pane
Status Panel
Toolbar
Viewport
Plugins
OpenVR (SteamVR)
Unity
Unreal Engine
Motion Builder
Maya
External Device Setup
Sync Configuration
AMTI Force Plate
Bertec Force Plate
NI-DAQ Devices
Peripheral API
Developer Tools
Overview
Motive API
NatNet SDK
Camera SDK
Baseline + Hinged Toe + Fingers (49)
Back to the Baseline Markerset page
Front view of the Baseline + Hinged Toe + Fingers (49) markerset.
Back view of the Baseline + Hinged Toe + Fingers (49) markerset.
Baseline + Hinged Toe + Fingers (49) Placements
[
edit
]
Head Markers
Label
Related Segment
Description
HeadTop
Head
Place the marker on the head tip.
HeadFront
Head
Place the marker at the center of the forehead.
HeadSide
Head
Place the marker on the either side of the head, slightly above the ear. When capturing multiple actors with similar proportions, place the marker on opposite side for clearer distinction.
Torso Markers
Label
Related Segment
Description
BackTop
Torso
Place the marker on the spine right below the neck. For best results, LUArmHigh-LShoulderBack-BackTop-RshoulderBack-RUArmHigh markers should align roughly in a straight line when the actor is in T-pose. Also, note that this marker must be placed at an elevation higher than the chest marker for the torso segment to be tracked properly.
Chest
Torso
Place the marker at the center of the sternum, about 5 cm below where the neck starts.
BackLeft
Torso
These two markers are located symmetrically on each side of the back, slightly below the lowest end of the shoulder blade (scapular bone).
BackRight
Torso
Waist Markers
Note that the waist markers are the key markers in modeling the pelvis bone, which is the major segment governing the other subsequent skeleton segments. For best results, avoid placing the waist markers in a rectangle shape. When tracking multiple actors with similar proportions, introduce an offset to one of the WaistBack marker, or the WaistCMarker (included only with the 13 additional markerset), to create an asymmetrical arrangements.
Label
Related Segment
Description
WaistLFront
Pelvis
Placed the marker on the protruding bone located on the front of the pelvis (left/right anterior iliac spine bone). The prominence can be palpated from left and right side of the waist.
WaistRFront
Pelvis
WaistLBack
Pelvis
Place the WaistLBack and WaistRBack markers above left/right hip; about 10 cm above the hip joint.
WaistRBack
Pelvis
Shoulder Markers
When placing the shoulder markers, ask the actor to stand in the
T-pose
in order to place the markers on accurate locations. It could also be helpful to ask the actor to do few rounds of arm abduction and adduction to palpate for the shoulder axis. These markers determine the width of the shoulder and respective relationship with the upper arm segment.
Label
Related Segment
Description
LShoulderBack
Shoulder
Place the marker on the shoulder joint (glenohumeral joint) on the back.
RShoulderBack
Shoulder
LShoulderTop
Shoulder
Place the marker at the top of each shoulder where you can palpate the protruding bone, which is usually located just before where the upper arm start when in T-pose. More specifically, the prominence is on the distal end of the clavicle bone (acrominoclavicular joint).
RShoulderTop
Shoulder
Arm Markers
Label
Related Segment
Description
LElbowOut
Upper Arm
Place the marker on the lateral side of the elbow joint, slightly towards the upper arm. More specifically, on the lateral epicondyle of the distal end of the humerous. Ask the actor to flex and extend the arm few times to confirm that markers are placed along the elbow axis and maintain stationary throughout the range of motion cycles.
RElbowOut
Upper Arm
LUArmHigh
Upper Arm
Place the marker on the back of the upper arm near the groove between the triceps. For best results, LUArmHigh, LShoulderBack, BackTop, RshoulderNack, and RUArmHigh should align roughly in a straight line when in T-pose.
RUArmHigh
Upper Arm
Hand + Finger Markers
Finger markersets include extra markers on the fingers, and the finger tracking is done by analyzing the kinematics of the hand and estimating the pose of each finger. The WristIn marker is removed and replaced by a forearm marker. Attaching finger markers uses mocap Velcro gloves and hand markers, which can be found from our
webstore
.
Label
Related Segment
Description
LFArm
Forearm
Place the marker on the front side of the forearm while in T-pose. For best results, slightly offset the left and right forearm markers to introduce the asymmetry on each side.
RFArm
Forearm
LWristOut
Fore Arm / Hand
This marker is not included in the finger markersets. Place the marker on the outside (lateral side) of the wrist axis. (distal end of the radius bone). Note that the wrist axis is not always located on the protruding bone but 1-2 cm more towards the hand.
RWristOut
Fore Arm / Hand
LThumb
Hand
Place the marker on the side of the thumb joint.
RThumb
Hand
LIndex
Hand
Place the marker on the side of the index finger joint (proximal interphalangeal joint).
RIndex
Hand
LPinky
Hand
Place the marker on the side of the pinky finger joint (proximal interphalangeal joint).
RPinky
Hand
LHandIn
Hand
Place the marker on the knuckle of the index finger, but slightly towards the side.
RHandIn
Hand
LHandOut
Hand
Place the marker on the knuckle of the pinky finger, but slightly towards the side.
RHandOut
Hand
Leg Markers
Label
Related Segment
Description
LThighFront
Upper Leg
Place the marker on the front side of the thigh, along the midline. For best results, slightly offset the height of the left and right markers to introduce the asymmetry.
RThighFront
Upper Leg
LKneeOut
Upper Leg
Place the marker on the outter prominence of the knee joint; on the lateral epicondyle of the femur. Palpate the knee for the protruding bone from the upper leg, and place it right on the axis. Ask the actor to flex and extend the knee few times to confirm that the markers are placed along the axis and maintain stationary throughout the range of motion cycles.
RKneeOut
Upper Leg
LShin
Lower Leg
Place the marker on the shin bone; on the midline of the lower leg. For best results, slightly offset the height of the left and right markers to introduce the asymmetry.
RShin
Lower Leg
Foot Markers
Label
Related Segment
Description
LAnkleOut
Lower Leg/Foot
Place the marker on the protruding bone outside of the ankle joint; on the lateral end of the malleolus bone.
RAnkleOut
Lower Leg/Foot
LToeOut
Foot
Place the marker just before the little toe joint; on the distal end of the fifth metatarsal bone.
RToeOut
Foot
LToeIn
Foot
Place the marker just before the big toe joint; on the distal end of the first metatarsal bone.
RToeIn
Foot
Hinged Toe Markers
Hinged toe markersets create toe segments in the skeleton. Two additional markers are added to each foot, one on the toe-tip and another on the heel. The hinged toe markers are included in all baseline markersets except for Baseline (37) and Upper Body markersets.
Label
Related Segment
Description
LHeel
Foot
Place at the center of the heel.
RHeel
Foot
LToeTip
Toe
Place the marker on the tip of the second toe; next to the big toe.
RToeTip
Toe
Categories
:
Baseline
Markerset
This page was last modified on 29 March 2016, at 16:44.
All data and information contained in or disclosed by this wiki is proprietary information of NaturalPoint Corporation and all rights therein are expressly reserved. By accepting this material the recipient agrees that this material and the information contained therein is held in confidence and in trust and will not be used, copied, reproduced in whole or in part, nor its contents revealed in any manner to others without the express written permission of NaturalPoint Corporation. Information in this document is preliminary and subject to change and does not represent a commitment on the part of NaturalPoint Corporation.