Main page → Active Marker Tracking → Active Puck
This page provides additional information for the Active pucks and instructions on how to use them.
The following specification applies for active IR LEDs on both the Tags and the Pucks.
Puck Body Dimensions
Bootloader: Pressing down on the button for longer than 3 seconds will set the puck at the bootloader state. At this state, both the top and bottom LED will turn orange, and the puck will not be operational. To exit out of this, you can just power off the puck and turn it back on.
Three plainly visible status LEDs for indication of battery status, sync status, and charging status.
The bottom LED indicates the sync status. When the puck is successfully synchronized with a base station, it will start receiving sync packets, and this bottom LED will start blinking green roughly at 10 Hz rate: